The steps to creating Embroidered Iron on Patches

There was a time when embroidered iron on patches were utilized to mainly cover up holes which might have happened over a dress. But with a little bit of versatility and imagination you can utilize this patch and bring an element of spunk and trend to any item of clothing you pick. It’s not just clothes on which you can use these patches but these embroidered iron on patches may be used to decorate bags, shoes, pillows, upholstery, hat’s�the list is as endless as your imagination.

In order to make tailored patches then you can definitely readily do it yourself. You can aquire all the resources that you will need very easily at stores where you could acquire available patches. The most important selling point of utilising an iron on patch is that you can devote all the time you would like to in making them but have to spend a short amount of time affixing them.

You will need to have your items on hand before you begin making your patch. But before you will get your resources think about the style of the patch that you want to make. Upon having the pattern made to size you must sketch or trace exactly the same on the cloth. Make sure that you don’t embroider the design and style on the cloth without the hoop in order for the completed pattern comes out flat. Now put a tear away backing fabric on the wrong side of the patch and fix the embroidery hoop in position so that the design is tight. You may even use some backing spray to attach your backing paper in position.

Now you may start out embroidering your iron on patch. Be sure that your thread is not longer than two feet at some point for you to embroider conveniently and don’t have to worry about unneeded tangles and knots. Now embroider across the design ensuring that you begin every length of the thread from the back of the design so the knots or extra lengths don’t appear at the front of the design.

Once you have completed embroidering your patch take it out of the hoop and remove the backing paper by tearing it off lightly. Take a little iron on sticky paper and cut it towards the same size of your patch. Now put your patch face-down on an ironing board and set the iron on sticky patch glue side down on your patch. Have a clear section of cloth or paper towel over the sheet. Set your iron on the low setting and iron the adhesive onto the patch. It’s also possible to use the silk setting on your iron. The paper towel or rag will make sure that not one of the glue gets stuck in your iron.

Your embroidered iron on patches is going to be set to work with after you complete this phase. Now all you need to do is peel off the paper backing the adhesive behind the patch, put it where you want to place it and iron it firmly in position. Iron the textile back to front so that the adhesive gets properly activated and keeps the patch in place.